Dark Light

IR DISTANCE SENSOR


  • Length: 13.53mm/0.53in
  • Width: 44.39mm/1.75in
  • Height: 18.67mm/0.75in
  • Weight: 3.5g/0.12oz

Screw holes are 37mm apart, 3.2.mm diameter.

350

IR DISTANCE SENSOR

The IR DISTANCE SENSOR bounces IR off objects to determine how far away they are. It returns an analog voltage that can be used to determine how close the nearest object is. Comes with 12″ long 3-JST interface wire. These sensors are good for short-range detection. For over 1 m distance, we suggest using sonar sensors

To use, connect black wire to ground, red wire to 5V and white wire to analog input. The analog voltage out will range from 3V when an object is only 4″ (10 cm) away and 0.4V when the object is 32″ (80 cm) away.

Infrared proximity sensor made by Sharp. Part # GP2Y0A21YK has an analog output that varies from 3.1V at 10cm to 0.4V at 80cm. The sensor has a Japanese Solderless Terminal (JST) Connector. We recommend purchasing the related pigtail below or soldering wires directly to the back of the module.

The GP2Y0A21 uses a 3-pin JST PH connector that works with our 3-pin JST PH cables for Sharp distance sensors (not included), as shown in the upper picture on the right. These cables have 3-pin JST connectors on one end and are available with pre-crimped male pins, pre-crimped female pins, and with unterminated wires on the other end. It is also possible to solder three wires to the sensor where the connector pins are mounted (see the lower picture to the right). When looking at the back, the three connections from left to right are power, ground, and the output signal. By liking Our Facebook Page Embeded Studio , you can get special discount. Data Sheet of IR DISTANCE SENSOR  can be also downloaded from the link

We also carry an assortment of mounting brackets designed specifically for this sensor:

Category: Tags: , ,

Based on 0 reviews

0.0 overall
0
0
0
0
0

Be the first to review “IR DISTANCE SENSOR”

There are no reviews yet.